STT

Technical properties

Value

first

Set time (start / end time)

200/440 minutes

2

Adhesive strength (after 28 days)

1.5 MPa

3

Bending strength (after 28 days)

6 MPa

4

Compressive strength (after 28 days)

14 MPa

5

Slippage

0 mm

      3. Step 3: Preparation:

     – Tools: Fly, glue table, tape measure, ruler, container, glue machine, …

    – Check the surface clean, check the flatness with straight ruler in accordance with TCVN error of ± 0.5 mm.

   – Concrete wall, plastered mortar wall ≥ 75.

   – Cleaning the surface of the wall, the bottom of the pool.

   – Moisten the walls by spraying water.

   – Paving with water (18-22% of water compared to the amount of glue). Mix the glue into a homogeneous mixture, no lumps. Time is about 7 – 10 minutes

       4. Step 4: Covering:

      – Apply 2-3 mm thick adhesive to the surface of the wall and the bottom of the pool.

      – Create a flat surface, create surface adhesion with a pedestal.

         Step 5: Mosaic Tiling:

       – Position the brick wall with the line from left to right from the top down.

        – Mesh glue with mesh surface on flat glue.

        – Handle the two corners of the blister paste and ke in the straight line on.

        – Use a scissors table to gently pull on the tile surface in a diagonal style and ensure that the tablets stick to the glue.

          6.  Step 6. Purge and clean (Make after Mosaic paste on glue 04 hours):

        – Wipe the surface before applying

        – Glue with clean water (water rate 28 – 30% compared to glue)

        – Use flexible plastic splinters to seal the circuit board into the mosaic circuit, filling the circuitry. glue-type cross-swimming swimsuit